← Reliability

EcoSpold 2 · Calculation comparison

ecoinvent 3.8 cut-off, ozone layer depletion

A comparison of published impact results with VoLCA calculations from the same source data and the publisher’s impact factors. Points on the diagonal agree.

Engine version
volca 0.14.0 (bd7e64a, v0.14.0, linux)
Measured on
Comparison measurements and reference
Databaseecoinvent 3.8 cut-off
Source formatEcoSpold 2
Impact method collectionecological scarcity 2013
Impact categoryozone layer depletion
UnitUBP
Activities compared18,274
Median ratio (VoLCA / published)1.0000
Comparison band1%
Activities outside the band0
Share outside the band0%
VerdictAgrees: meets the agreement a release is held to
Points drawn1,828
Largest relative deviation0%
Activity with largest deviationmarket for used sealing tape aluminium/PE, 50 mm wide
Published referenceecoinvent 3.8_cutoff_cumulative_lcia_xlsx.7z
ecoinvent 3.8 cut-off, ozone layer depletion
Each point is one activity: what ecoinvent 3.8 cut-off published for ozone layer depletion (UBP), against what VoLCA computes from the same EcoSpold 2 source under the publisher's own ecological scarcity 2013 factors. The black line is equality and the grey band is 1%. 18,274 activities were compared; 1,828 from inside the band are drawn, evenly spaced over the published value. Where several fall on one spot, at most three markers are drawn there, since a fourth would not darken it. Median ratio 1.0000, 0.00% outside the band. This meets the agreement a release is held to: at most 5% of activities outside the band and a median ratio inside it.